VTech Power Zone 2000 Installation Guide download pdf (Page 39)

Synapse Installation Guide 39 [Headset] TL7600 Cordless Headset Installation

[Headset] Battery Installation

Install the battery as shown below. For optimal performance, charge the Headset battery for at least six hours before use. When

not in use, recharge the Headset by returning it to the Headset Charger.

 To install a battery:

Figure 44. Remove Battery Door

Figure 45. Insert Battery and Plug

1. If the battery door is attached, press

on both sides of the battery

compartment cover and lift the cover

up and off as shown in Figure 44.

2. Insert the battery into the battery

compartment with the label THIS

SIDE UP facing up as shown in

Figure 45.

3. Push the battery plug into the

connector inside the compartment

according to the color-coded label and place the wires neatly inside the

compartment as shown in Figure 45.

4. Insert the tab on the bottom of the battery cover into the battery compartment.

Press down gently on the battery cover until it snaps into place as shown in

Figure 46.

Battery Door

Insert Battery

Insert Plug

Figure 46. Replace Battery Door

Battery Door

Remove the ear hook from the Headset before battery replacement.

Use only the supplied rechargeable battery or replace it with battery

model BT191545. To obtain a replacement battery, visit our website at

www.telephones.att.com/smb or call 1 (888) 916-2007.

In Canada, dial

1 (888) 883–2474.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44

No comments

VTech Power Zone 2000 Installation Guide Page 39