VTech Power Zone 2000 Installation Guide download pdf (Page 35)

Synapse Installation Guide 35 [Handset] SB67040 Cordless Handset Installation

[Handset] Battery Installation

The Handset uses a rechargeable 2.4v nickel-metal hydride cell (NiMH) pack and comes with a battery Charger.

 To install the Handset battery:

Figure 38. Install Handset Battery

1. Remove the battery cover by pressing and sliding the cover downward, as

shown in Figure 38.

2. Plug the battery connector securely into the plug inside the Handset

battery compartment, matching the color-coded label.

3. Place the battery in the compartment with THIS SIDE UP facing up.

4. Align the cover flat against the battery compartment, then slide it upward

until it clicks into place.

5. Press PHONE. The LCD displays a blank screen during startup.

 After startup, if the battery is sufficiently charged, the LCD displays the

screen shown in Figure 39.

 If the screen is blank, place the Handset in the Charger.

Figure 39. Place In Charger

Color-Coded

Battery Connector

12:00a Jan. 0012:00a Jan. 00

Place in charger.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 43 44

No comments

VTech Power Zone 2000 Installation Guide Page 35