VTech Power Zone 2000 Installation Guide download pdf (Page 17)

Synapse Installation Guide 17 Gateway Installation

Completing the Gateway Installation

 To complete the Gateway installation:

1. Remove the plastic covers from the Gateway PSTN (telephone) jacks to be used,

marked LINE 1 through LINE 4 and BYPASS.

2. Plug up to four telephone lines from the telephone wall jacks into the Gateway. The

line LEDs blink up to 15 seconds during initialization.

For information on configuring and troubleshooting the Synapse telephone system, see the “Synapse Administrator’s

Guide” at

www.telephones.att.com/synapseguides.

Figure 15. DSL Connection

If you subscribe to Digital Subscriber Line (DSL) high-speed Internet

service through your telephone line, you must plug each telephone line

with DSL service into a DSL filter. Then plug the DSL filter into the

telephone wall jack, as identified in Figure 15.

For communication during power outages, plug an analog telephone into the BYPASS port and a PSTN line into

LINE 4.

For customer service or product information, contact the installer at the number on the cover of this guide. If your

installer is unavailable, visit our website at

www.telephones.att.com/smb or call 1 (888) 916-2007. In

Canada dial

1 (888) 883-2474.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 43 44

No comments

VTech Power Zone 2000 Installation Guide Page 17