VTech UP407 User Manual download pdf (Page 17)

Getting started

Battery installation and charging

Getting started

Wall mount installation

The charger is ready for tabletop use. If you want to mount the

charger on a wall, use two 10mm screws and wall anchors (not

provided) to hold the charger in place. The screws and wall

anchors are available for purchase in many hardware or consumer

electronics retailers. You might need a professional to install the

charger.

To mount the charger on the wall

1. Use a pencil to mark the desired positions of the two holes on

the wall, make sure the space between the two holes is 30mm.

Drill two holes in the wall according to the marks.

Screw spacing 30mm

(1.18 inches)

2. If you drill the holes into a stud, go to step 3.

-OR-

If you drill the holes into an object other than a stud, insert the

wall anchors (not provided) into the holes and tap gently on the

ends with a hammer until the wall anchors are flush with the

wall.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 49 50

No comments

VTech UP407 User Manual Page 17