VTech CS6719 User Manual download pdf (Page 9)

Important safety instructions

When using your telephone equipment, basic safety precautions should always be followed to reduce the risk of re, electric

shock and injury, including the following:

Read and understand all instructions.

Follow all warnings and instructions marked on the product.

Unplug this product from the wall outlet before cleaning. Do not use liquid or aerosol cleaners. Use a damp cloth for

cleaning.

Do not use this product near water such as near a bath tub, wash bowl, kitchen sink, laundry tub or a swimming pool, or in

a wet basement or shower.

Do not place this product on an unstable table, shelf, stand or other unstable surfaces.

Slots and openings in the back or bottom of the telephone base and handset are provided for ventilation. To protect them

from overheating, these openings must not be blocked by placing the product on a soft surface such as a bed, sofa or rug.

This product should never be placed near or over a radiator or heat register. This product should not be placed in any area

where proper ventilation is not provided.

This product should be operated only from the type of power source indicated on the marking label.

If you are not sure of the type of power supply in your home or ofce, consult your dealer or local

power company.

Do not allow anything to rest on the power cord. Do not install this product where the cord may be walked on.

Never push objects of any kind into this product through the slots in the telephone base or handset because they may

touch dangerous voltage points or create a short circuit. Never spill liquid of any kind on the product.

To reduce the risk of electric shock, do not disassemble this product, but take it to an authorized service facility. Opening

or removing parts of the telephone base or handset other than specied access doors may expose you to dangerous

voltages or other risks. Incorrect reassembling can cause electric shock when the product is subsequently used.

Do not overload wall outlets and extension cords.

Unplug this product from the wall outlet and refer servicing to an authorized service facility under the following conditions:

When the power supply cord or plug is damaged or frayed.

If liquid has been spilled onto the product.

If the product has been exposed to rain or water.

If the product does not operate normally by following the operating instructions. Adjust only those controls that

are covered by the operation instructions. Improper adjustment of other controls may result in damage and often

requires extensive work by an authorized technician to restore the product to normal operation.

If the product has been dropped and the telephone base and/or handset has been damaged.

If the product exhibits a distinct change in performance.

Avoid using a telephone (other than cordless) during an electrical storm. There is a remote risk of electric shock from

lightning.

Do not use the telephone to report a gas leak in the vicinity of the leak. Under certain circumstances, a spark may

be created when the adapter is plugged into the power outlet, or when the handset is replaced in its cradle. This is a

common event associated with the closing of any electrical circuit. The user should not plug the phone into a power outlet,

and should not put a charged handset into the cradle, if the phone is located in an environment containing concentrations

of ammable or ame-supporting gases, unless there is adequate ventilation. A spark in such an environment could

create a re or explosion. Such environments might include: medical use of oxygen without adequate ventilation;

industrial gases (cleaning solvents; gasoline vapors; etc.); a leak of natural gas; etc.

Only put the handset of your telephone next to your ear when it is in normal talk mode.

The power adapters are intended to be correctly oriented in a vertical or oor mount position. The prongs are not

designed to hold the plug in place if it is plugged into a ceiling, under-the-table or cabinet outlet.

SAVE THESE INSTRUCTIONS

Precautions for users of implanted cardiac pacemakers

Cardiac pacemakers (applies only to digital cordless telephones):

Wireless Technology Research, LLC (WTR), an independent research entity, led a multidisciplinary evaluation of the

interference between portable wireless telephones and implanted cardiac pacemakers. Supported by the U.S. Food and Drug

Administration, WTR recommends to physicians that:

Pacemaker patients

Should keep wireless telephones at least six inches from the pacemaker.

Should NOT place wireless telephones directly over the pacemaker, such as in a breast pocket, when it is turned ON.

Should use the wireless telephone at the ear opposite the pacemaker.

WTR’s evaluation did not identify any risk to bystanders with pacemakers from other persons using wireless telephones.

Operating range

This cordless telephone operates with the maximum power allowed by the Federal Communications Commission (FCC). Even

so, this handset and telephone base can communicate over only a certain distance - which can vary with the locations of the

telephone base and handset, the weather, and the layout of your home or ofce.

When the handset is out of range, the handset displays Out of range or no pwr at base.

If there is a call while the handset is out of range, it may not ring, or if it does ring, the call may not connect well when you press

. Move closer to the telephone base, then press to answer the call.

If the handset moves out of range during a telephone conversation, there may be interference. To improve reception, move

closer to the telephone base.

Energy-saving charging mode

When this mode is activated, all telephone functions, except handset battery charging, will be disabled.

To activate the energy-saving charging mode:

1. Unplug the telephone base power adapter from the power outlet. Make sure all handsets are plugged with charged batteries

before proceeding.

2. While you press and hold /FIND HANDSET, plug the telephone base power adapter back to the power outlet.

3. After about 20 seconds, when the IN USE light starts ashing, release /FIND HANDSET and then press it again within 2 seconds.

When the phone successfully enters the energy-saving charging mode, the IN USE light turns off and all handsets

display To register HS... and ...see manual alternately.

When the phone fails to enter this mode, repeat Step 1 through Step 3 above.

Note: The telephone base will be powered up as normal if you fail to press /FIND HANDSET within 2 seconds in Step 3.

To deactivate the energy-saving charging mode:

1. Unplug the telephone base power adapter from the power outlet, then plug it back in. Then the telephone base is powered up

as normal.

2. Register your handsets back to the telephone base. See the online Complete user’s manual at www.vtechphones.com for handset

registration instructions.

10.

11.

12.

•

13.

14.

15.

16.

•

1 2 3 4 5 6 7 8 9 10 11 12

Comments to this Manuals

No comments

VTech CS6719 User Manual Page 9

Comments to this Manuals

Related products and manuals for Telephones VTech CS6719