VTech LS6245 User Manual download pdf (Page 67)

9. REGISTRATION

Your handset and base station is pre-registered. Up to five handsets can be registered to a single base station.

If for some reason, the handset is not registered to the base station ("NOT REGISTERED" displays in the handset screen), register your

handset according to the following procedures.

Using a handset:

1. Put the handset on the base, "PRESS HOLD ON BASE FOR 4 SEC" will display in the handset screen.

Or use your handset menu.

1. Press MENU and

U/D on the handset to select SETTINGS.

2. Press SELECT and

U/D to select REGISTER.

3. Press SELECT to enter the system PIN. (Default is 0000)

4. Press OK and go ahead with the following procedures using the base.

Using the base:

5. Press and hold

H on the base for about four seconds until the telephone base displays “REGISTERING HANDSET...”. The handset

shows “HANDSET X REGISTERED” (X represents the handset number assigned) and you hear a beep when the registration completes.

Note:

If the registration fails, "NO BASE FOUND" displays in the handset screen and then "TO REGISTER, PICK UP HANDSET FROM CHARGER"

displays. Try the registration process again.

You cannot register a handset if any other system handset is in use.

VTech LS6245_HK version_IFU_EN.book Page 63 Friday, September 23, 2011 1:01 PM

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 90 91

No comments

VTech LS6245 User Manual Page 67