Vtech CORDLESS TELEPHONE VT 9152 User Manual download pdf (Page 6)

SETTING UP YOUR

VT 9152

GETTING STARTED

TELEPHONE

WALL JACK

AC ELECTRICAL

OUTLET

1. Choose an area near an electrical outlet and a telephone wall jack.

2. Plug the AC power adapter into an electrical outlet and the DC connector to the back of

the base unit.

CAUTION: Use only the AC adapter shipped with your VT 9152. It is specifically designed

for this product.

NOTE: Connect power to the base unit before placing the handset in the cradle.

3. CHARGE THE HANDSET BATTERY PACK BEFORE USE. The batteries recharge

automatically whenever the handset is in the base unit cradle. The batteries must be

charged for 16 hours before using your phone for the first time.

4. Connect the telephone line cord. Insert one end of the telephone line cord into the jack at

the rear of the base unit. Plug the other end into a telephone wall jack. Make sure the plugs

snap securely into place.

5. CHECK FOR A DIAL TONE. After the batteries are charged, pick up the handset and

press the PHONE key. The IN USE indicator should light up, and you should hear a dial

tone. If not, see IN CASE OF DIFFICULTY.

CAUTION:

1. Never install telephone wiring during a lightning storm.

2. Never install telephone jacks in wet locations unless the jack is specifically designed for

wet locations.

3. Never touch uninsulated telephone wires or terminals unless the telephone line has been

disconnected at the network interface.

4. Use caution when installing or modifying telephone lines.

1 2 3 4 5 6 7 8 9 10 11 ... 27 28

No comments

Vtech CORDLESS TELEPHONE VT 9152 User Manual Page 6