Vtech CORDLESS TELEPHONE VT 9152 User Manual download pdf (Page 5)

REPLACING THE HANDSET BATTERIES

GETTING STARTED

1. Slide the battery cover off by gently

pressing on the recessed area with

a downward motion.

2. Unplug and remove the old battery

pack. Don't put the old battery pack

in a trash compactor or a fire - it

could burst.

3. Plug in the replacement battery

pack. Place the battery pack in the

compartment with the battery cord

resting on top of it.

4. Replace the battery cover by

sliding it into place.

5. The new battery pack must be

charged before using your

telephone. Place the handset in the

cradle of the base unit to allow it to

charge for 16 hours.

CAUTION: To reduce the risk of fire or injury, read and follow these instructions:

1. Use only VTECH battery pack.

2. Do not open or mutilate the battery. Released electrolyte is corrosive and may cause

damage to the eyes or skin. It may be toxic if swallowed.

3. Exercise care in handling batteries in order not to short the battery with conducting

materials such as rings, bracelets, and keys. The battery or conductor may overheat and

cause burns.

4. Do not dispose of the battery in a fire. The cell may explode.

Recharging the Battery Pack

Your

VT 9152

provides both audible and visual alerts when the battery pack is low and

requires charging. Return the Handset to the Base cradle when:

1. The IN USE/LOW BATT LED is slowly flashing; and/or

2. You hear a

double beep

while you’re on a call or when you press PHONE/FLASH to make

or answer a call.

When fully charged, you will experience up to 5 hours of continuous talk, or up to 6 days of

standby (off the cradle, but not in use).

1 2 3 4 5 6 7 8 9 10 ... 27 28

No comments

Vtech CORDLESS TELEPHONE VT 9152 User Manual Page 5