36
Appendix
Troubleshooting (continued)
The battery does not charge in the parent unit or the parent unit battery
does not accept charge.
Make sure the battery is installed in the parent unit battery compartment correctly. The
light on the parent unit should be on when charging.
Remove the battery and then install it again, then charge for up to 12 hours.
If the battery icon and the light on the parent unit are not on, refer to The light
on the parent unit is off below.
If the battery is completely depleted, it may take up to 30 minutes to charge the parent
unit before it can be used for a short time (page 13).
Purchase a new battery. Refer to Parent unit battery installation (pages 10-11) and
Parent unit battery charging (page 13).
The light on the parent unit is off.
Make sure the parent unit battery is installed (page 10) and charged (page 13) correctly.
The light is off when the battery is fully charged even if it is also powered by
AC power.
The parent unit beeps and is not performing normally.
Move the parent unit closer to the baby units (but not less than 3 feet). The parent unit(but not less than 3 feet). The parent unit. The parent unit
may be out of range.
If the parent unit is powered by the provided battery, it may not have enough charge
for the parent unit to perform normally. Charge the battery in the parent unit for up to
12 hours.
Reset the parent unit and the baby units by turning them off and unplugging the
electrical power to the parent unit and the baby units. Wait for 15 seconds and plug
them back in again. Turn on the parent unit and the baby units. Allow up to one minute
for the parent unit and the baby units to synchronize.
Other electronic products may cause interference with your video and audio monitor.
Try installing your video and audio monitor as far away from these electronic devices
as possible: wireless routers, radios, cellular telephones, intercoms, room monitors,
televisions, personal computers, kitchen appliances and cordless telephones.
The link between the baby unit and the parent unit is lost every now and
then, and I’m experiencing sound interruptions.
Move the parent unit closer to the baby unit (but not less than 3 feet). The parent unit
may be out of range.
Reset the parent unit and the baby unit by turning them off unplugging the electrical
power to the parent unit and the baby unit. Wait for 15 seconds and plug them back in
again. Turn on the baby unit and the parent unit. Allow up to one minute for the parent
unit and the baby units to synchronize.
•
•
•
•
•
•
•
•
•
•
•
•
•
(24 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals