VTech Power Vision User Manual download pdf (Page 39)

Appendix

Parent unit battery

It takes up to 12 hours for the battery to be fully charged.

The standby time varies depending on the sensitivity level you set, your actual use and

the age of the battery.

The battery needs charging when:

A new battery is installed in the parent unit.

The parent unit beeps.

The battery is properly installed and no battery icon displays on the screen.

Battery low at Parent Unit and displays on the parent unit.

The light ashes on the parent unit.

CAUTION:

To reduce the risk of re or injury, read and follow these instructions:

Use only the battery provided or equivalent. To order a replacement, visit our website

at www.babymonitors.vtech.com or call 1 (800) 595-9511. In Canada, go to

www.vtechcanada.com or call 1 (800) 267-7377.

Do not dispose of the battery in a re. Check with local waste management codes for

special disposal instructions.

Do not open or mutilate the battery. Released electrolyte is corrosive and may cause

burns or injury to the eyes or skin. The electrolyte may be toxic if swallowed.

Exercise care in handling the battery in order not to create a short circuit with

conductive materials.

Charge the battery provided with or identied for use with this product only in

accordance with the instructions and limitations specied in this manual.

Observe proper polarity orientation between the battery and metallic contacts.

To prevent re or shock hazard, do not expose this product to water or any type

of moisture.

•

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 51 52

No comments

VTech Power Vision User Manual Page 39