VTech C4001 User's Guide download pdf (Page 47)

Installation

SIP contemporary cordless 1-line/2-line - S2410/CTM-S2411/S2420/CTM-S2421

Installation option - converting from desktop to wall mount position

To mount the telephone base on the wall:

Unplug the Cat-5 network cable from the network wall jack.

Remove the cordless handset from the telephone base if it is cradled in the telephone base. On the telephone base, place a coin

in the slit of the wall mount clip and rotate a half turn (180 degrees). It locks into place with the protruding edge pointing towards

the upper edge of the telephone base. This protruding edge holds the handset when the phone is mounted on the wall.

Turn the telephone base over with the bottom side facing up. To remove the mounting bracket, rmly press down the tabs on the

mounting bracket and pull them out from the grooves on the telephone base.

Mount the telephone base on the wall by aligning the eyelets with the mounting studs of the wall plate. Then slide the telephone

base down on both mounting studs until it locks into place.

Plug the Cat-5 network cable back into the network wall jack with Power over Ethernet (PoE). Then replace the cordless

handset on the telephone base cradle.

Protruding edge

Mounting

bracket

Eyelets

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 93 94

No comments

VTech C4001 User's Guide Page 47