VTech Movie Magic Digicam User Manual download pdf (Page 6)

NOTE: The actual capacity depends on the shooting environment.

GETTING STARTED

BATTERY INSTALLATION

Note: Adult assembly is required for

battery installation. Tools required for

battery installation: Slotted (at head)

screwdriver / coin (not included).

• Make sure the video camera is turned OFF.

• Locate the battery cover on the bottom of the video camera. Loosen

the screw using a screwdriver and remove the battery cover.

• Install 4 “AA” batteries as illustrated above. (The use of new, alkaline

batteries is recommended for maximum performance. Ni-MH

rechargeable batteries are also supported.)

• Replace the battery cover and tighten the screw. Do not over-tighten

the screw.

Note: If Movie Magic DigiCam™ is not working properly after the

batteries have been replaced, press the Reset Button and then restart

the video camera.

BATTERY NOTICE

• The use of new alkaline batteries is recommended for maximum

performance.

• Non-rechargeable batteries are not to be recharged.

• Rechargeable batteries are to be removed from the toy before being

charged (if removable).

• Rechargeable batteries are only to be charged under adult supervision

(if removable).

• Do not mix old and new batteries.

• Do not mix batteries of different types: alkaline, standard (carbon-zinc)

or rechargeable (nickel-cadmium)

• Only batteries of the same or equivalent type as recommended are to

be used;

• Batteries are to be inserted with the correct polarity.

• Exhausted batteries are to be removed from the toy.

• The supply terminals are not to be short-circuited.

• The toy is not to be connected to more than the recommended number

of power supplies.

• Do not dispose of batteries in re.

Getting Started

1 2 3 4 5 6 7 8 9 10 11 ... 19 20

No comments

VTech Movie Magic Digicam User Manual Page 6