VTech 2568 Operations Instructions download pdf (Page 39)

FCC AND IC REGULATIONS

This equipment complies with Parts 15 of the Federal Communications

Commission (FCC) rules for the United States. It also complies with

regulations RSS210 and CS-03 of Industry and Science Canada. Operation

is subject to the following two conditions: (1) this device may not cause

interference, and (2) this device must accept any interference, including

interference that may cause undesired operation of the device.

A label is located on the underside of the Base Unit containing either the

FCC registration number and Ringer Equivalence Number (REN) or the IC

registration number and Load Number. You must, upon request, provide

this information to your local telephone company.

This equipment is compatible with inductively coupled hearing aids.

Should you experience trouble with this telephone equipment, please contact:

VTech Communication Inc

SERVICE DEPT. at 1-800-595-9511. In Canada, call VTECH Electronics

at 1-800-267-7377.

For repair/warranty information. The telephone company may ask you to disconnect

this equipment from the line network until the problem has been corrected.

FCC Part 15

Warning: Changes or modifications to this unit not expressly approved

by the party responsible for compliance could void the user's authority to

operate the equipment.

The equipment has been tested and found to comply with part 15 of the

FCC rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged

to try and correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet or on a circuit different from

that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 45 46 47

No comments

VTech 2568 Operations Instructions Page 39