VTech 2568 Operations Instructions download pdf (Page 33)

If the phone doesn’t work at all, check these items first:

• Make sure the AC adapter is plugged into an outlet not controlled

by a wall switch.

• Make sure the telephone line cord is plugged firmly into the base unit

and the modular jack.

• Make sure the base antenna is fully upright.

• If the handset does not beep when you press

PHONE

, the battery

might need charging.

• Make sure the battery pack is installed correctly.

• If you have dial pulse (rotary) service on your phone line, make sure

the dial mode is set to dial pulse (see INSTALLATION).

• Microwave appliances may cause interference with this phone. If you

experience interference, move away from the microwave.

If the above suggestions don’t solve the problem, try

re-initializing the handset and base:

1 Disconnect the power to the base.

2 Remove the handset battery pack.

3 Wait a few minutes.

4 Connect the power to the base.

5 Insert the handset battery pack.

6 Put the handset in the base to re-initialize.

If you hear a two-beep signal when you try to use the handset:

• You might be out of range. Move closer to the base and try again.

• If moving closer to the base doesn’t help, try following the directions

above for re-initializing the handset and base.

If the phone does not ring when you receive a call:

• Make sure the handset ringer is on.

• Make sure the telephone line cord is connected firmly to the base

and the telephone jack.

• Make sure the AC adapter is plugged firmly into an outlet not controlled

by a wall switch.

• You might be too far from the base; move closer.

• You might have too many extension phones on your telephone line to

allow all of them to ring. Try unplugging some of them.

IN CASE OF DIFFICULTY

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 46 47

No comments

VTech 2568 Operations Instructions Page 33