VTech vt9121 Operations Instructions

1INTRODUCTIONParts Check List:1. Handset2. Base Unit3. Telephone line cord4. AC adapter5. Battery Pack6.Wall mounting bracketWALL MOUNT BRACKETTE

10(the * key). You can then press the numbersor symbols you need, and your phone willsend the proper signals.To end the call, press OFF or place theha

11OPERATING INSTRUCTIONS2. Press 83. Press and hold 9 until it beeps at least twice.4. Dial 555-12345. Press MEMUsing REDIALTo REDIAL the last number

12Your VT9121 cordless phoneCALLER IDA WORD ABOUT CALLER ID - CIDDue to regional incompatibilities, Caller IDinformation may not be available for eve

13Caller ID LCD and IconsCaller ID information is displayed on the BaseLCD module. Each ICON has a specificfunction.New Call Icon (NEW CALL)When acti

14“LINE ERROR” is displayed if errorsare detected during the receptionof Caller ID information. Thisdoes not indicate a problem with yourunit. Notify

15DEL. This key is primarily used todelete stored numbers in the CallerID memory. See “Deleting Caller ID Memory”,page 23. The DEL key isalso used

16Enter Time:*Using the scroll keys ( and ) selectthe correct hour (1,2,3,...12). To confirm yourselection press the DEL key.*Using th

17To review the calls, simply press theand keys to scroll through the Caller IDmemory. The key moves backwardthrough the list, while

18Caller ID with Call Waiting Requirement:User must be a subscriber to the caller ID with Call Waiting (CIDCW) service offered by the local telephone

19 IN CASE OF DIFFICULTYTHE HANDSET DOES NOT RING WHEN YOURECEIVE A CALL.* Ensure that the ringer is turned on.* Make sure the telephone line cord is

2IMPORTANT SAFETY INSTRUCTIONSwork is required, contact VTech CustomerService at 1-800-595-9511. Opening orremoving cabinet parts other than specifie

20WARRANTY STATEMENTor incorporated into other products* Products purchased outside the USA* Products serviced by the owner or aservice facility not e

21 MAINTENANCETECHNICAL SPECIFICATIONSTAKING CARE OF YOUR TELEPHONEYour VT 9121 cordless telephone containssophisticated electronic parts so it mu

22FCC AND IC REGULATIONScircuit different from that to which the receiveris connected.* Consult the dealer or an experienced radio/TV technician for h

23telecommunications network,protective, operational and safetyrequirements. Industry Canadadoes not guarantee the equipmentwill operate to the user’s

3REPLACING THE HANDSET BATTERIESCAUTION: To reduce the Risk of Fire orInjury to Persons, Read andFollow these instructions:1. Use only VTECH battery.2

4SPARE BATTERY CHARGERSPARE BATTERY CHARGERYour VT 9121 ADLc is equipped with a spare battery charger built-in to the base unit. Thespare battery cha

5GETTING STARTED5. Connect the telephone line cord. Insert oneend of the telephone line cord into the jackat the rear of the base unit. Plug the oth

6wallboardwoodenstudWALL MOUNTING4.Connect the telephone cord. Thetelephone line cord has a snap-in plug ateach end. Insert one of the plugs into thej

7HANDSET FEATURESPGM KEY* Press PGM key to enter PROGRAM mode.See Programming Speed Dial Numbersfor more details.REDIAL KEY* When you hear the dial to

8BASE UNIT FEATURESCHARGING LED* The CHARGING LED illuminates steadilywhen the handset is in the base cradle toindicate that the handset battery is be

9OPERATING INSTRUCTIONSIMPORTANT:Whenever the handset batteries are removed,the handset must be reinitialized on the baseunit cradle after the batteri