1User’s manualIS741DECT 6.0 accessory doorbell for use with VTech models IS7121/IS7121-2/IS7121-22Congratulationson purchasing your new VTech product
10Tighten the screwTighten the screw into the threaded socket at the bottom to secure.8.Plug the adapter into the indoor domestic power supply.9.Plug!
11After an extended exposure to cold, heat or humidity, the doorbell gasket rubber may become sticky.If you need to remove the doorbell from its wall
12If you already have a wired doorbell installed, follow the instructions below to install your new IS741 doorbell unit.Turn off the power supply to t
13Important safety instructionsWhen using your telephone equipment, basic safety precautions should always be followed to reduce the risk of re, elec
14Precautions for users of implanted cardiac pacemakersCardiac pacemakers (applies only to digital cordless telephones):Wireless Technology Research,
15How long is the limited warranty period?The limited warranty period for the Product extends for ONE (1) YEAR from the date of purchase. If VTech rep
16FCC Part 68 and ACTAThis equipment complies with Part 68 of the FCC rules and with technical requirements adopted by the Administrative Council for
2Basic steps to install your doorbell1Install doorbell battery 2Doorbell power adapter installation3Add and register a doorbell4Doorbell location test
32Doorbell power adapter installationLoosen the screws and the metallic plates, then slide the metal part of the wires underneath the metallic plates
43Add and register a doorbellYou can add another new doorbell (purchased separately) to your IS7121 telephone system. This telephone system accommodat
5Before mounting the doorbell on a wall, make sure you test if the location you install the doorbell is in range, and adjust the camera angle to best
6To adjust the shooting area, you may either relocate the doorbell in different height level, or adjust the camera angle (see below). To adjust the ca
7Use the two holes on the doorbell wall mount cover to mark the desirable installation location on the wall.1.5Doorbell wall mount installationMake su
8Align the wall mount cover and screws with the holes in the wall (or stud).3.Align Loosen the screws and the metallic plates to release the wires fro
9Slide the metal part of the wires underneath the metallic plates as shown. Twist the screws to secure.6.Wire with red endWire with black endScrewsMet
Comments to this Manuals