Vtech IS741 Manual User Manual

1User’s manualIS741DECT 6.0 accessory doorbell for use with VTech models IS7121/IS7121-2/IS7121-22Congratulationson purchasing your new VTech product

10Tighten the screw7. Tighten the screw into the threaded socket at the bottom to secure.Plug the adapter into the indoor domestic power supply.8.Plu

11After an extended exposure to cold, heat or humidity, the doorbell gasket rubber may become sticky.If you need to remove the doorbell from its wall

12If you already have a wired doorbell installed, follow the instructions below to install your new IS741 doorbell unit.Turn off the power supply to t

13Important safety instructionsWhen using your telephone equipment, basic safety precautions should always be followed to reduce the risk of re, elec

14Precautions for users of implanted cardiac pacemakersCardiac pacemakers (applies only to digital cordless telephones):Wireless Technology Research,

15How long is the limited warranty period?The limited warranty period for the Product extends for ONE (1) YEAR from the date of purchase. If VTech rep

16FCC Part 68 and ACTAThis equipment complies with Part 68 of the FCC rules and with technical requirements adopted by the Administrative Council for

2Basic steps to install your doorbell1Install doorbell battery 2Doorbell power adapter installation3Add and register a doorbell4Doorbell location test

32Doorbell power adapter installationLoosen the screws and the metallic plates, then slide the metal part of the wires underneath the metallic plates

43Add and register a doorbellYou can add another new doorbell (purchased separately) to your IS7121 telephone system. This telephone system accommodat

5Before mounting the doorbell on a wall, make sure you test if the location you install the doorbell is in range, and adjust the camera angle to best

6ViewRightAngleAdjustmentViewLeftCAUTIONViewRightAngleAdjustmentViewLeftCAUTIONAvoid placing other cordless devices near the doorbell. They may cause

7Use the two holes on the doorbell wall mount cover to mark the desirable installation location on the wall.1.Make sure you have done Step 4 above bef

8Align the holes on the wall mount cover with the holes on the wall. Tighten the screws into the holes to secure the wall mount cover onto the wall.3.

9Loosen the screws and the metallic plates, then slide the metal part of the wires underneath the metallic plates as shown. Twist the screws to secure